michael's FotoPage

By: michael williams

[Recommend this Fotopage] | [Share this Fotopage]
View complete fotopage

Saturday, 27-Aug-2011 03:11 Email | Share | Bookmark
Fitting A Bath Screen

Prior to fitting a bath screen it is crucial to examine the adhering to: \n
  • There are no electrical cables or pipe operate behind the surface area exactly where drilling is required to resolve the
  • display to the wall.
  • The wall to which the screen is to be fitted is reasonably flat and that the bath is stage and steady.
  • The rim of the bath slopes inward, which will make sure that any water running of the display screen will
  • drain into the bath.
  • There are no obstructions to stop the screen from swiveling on its hinges.
Also check out that you have the correct equipment accessible for the task, there is nothing at all even worse than starting the fitting and realising that you have not obtained a particular device and then have to end operate whilst you go and obtain 1 or borrow one.Equipment you could require are: \n
  • Electrical power or hand drill
  • 6mm masonry drill bit
  • three.5mm HSS drill bit
  • Spirit levels
  • Pozidrive screwdriver
The most important factor to bear in mind is that if the wall channel is not levels then the display screen by itself could swing of its individual accord (possibly inwards or outwards) as it is pivoting about both the bottom or top of the channel. It might also now in shape towards the rim of the bath tub either leaving a gap which drinking water will leak out onto the floor by way of or it may not even close onto the edge of the bath as it bangs on the edge.So remember take care at this stage, use a spirit stage and the moment you have the channel in place the rest of the fitting should be basic sailing.Bath Screens\nRelated Sites : Bath screen


View complete fotopage


© Pidgin Technologies Ltd. 2016

ns4008464.ip-198-27-69.net